Creating A Catalog Product And Purchase Record - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

After you have discovered products, choose one whose compliance you want to monitor.
1 In ZENworks Control Center, click the Asset Management tab, then click the License
Management tab.
2 In the License Management panel, click Discovered Products to display the Discovered
Products list.
3 Browse the list to choose the discovered product you want to use.
The product must have a least one installation listed in the Installed Quantity column. If
possible, you should choose a product for which you have a purchase order or invoice readily
available. This allows you to complete the scenario using real information. Otherwise, you can
invent the purchase information as you go. Remember your product choice so that you can use
it later.
4 Continue with the next section,

4.8.3 Creating a Catalog Product and Purchase Record

Discovered products provide the installation information for products. To provide information about
product purchases, you create catalog products and purchase records.
A catalog product represents a software product. A purchase record populates the catalog product
with the number of product licenses you've purchased.
The following steps explain how to create a catalog product and purchase record for the discovered
product you chose in Section 4.8.2, "Discovering Installed Products," on page
1 In ZENworks Control Center, click the Asset Management tab, then click the License
Management tab.
2 Create the catalog product:
2a In the License Management panel, click Catalog Products.
"Creating a Catalog Product and Purchase Record" on page 69.
68.
Device Management 69