Performing A File Transfer Operation - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

Enable Logging: Logs session and debug information in the
file. The file is saved by default on the desktop if you launch ZENworks
vncviewer.txt
Control Center through Internet Explorer and in the Mozilla installed directory if you launch
ZENworks Control Center through Mozilla FireFox.
6 Click OK to launch the session.

4.4.5 Performing a File Transfer Operation

1 In ZENworks Control Center, click the Devices tab.
2 Navigate the
Servers
manage.
3 Select the device by clicking the check box in front of the device.
4 In the task list located in the left navigation pane, click Transfer Files to display the File
Transfer dialog box.
5 In the File Transfer dialog box, fill in the following fields:
Device: Specify the name or the IP address of the device you want to access.
Authentication: Select the mode you want to use to authenticate to the managed device. The
two options are:
Password: Provides password-based authentication to perform an operation. You must
enter the correct password as set by the user on the managed device or as configured by
the administrator in the security settings of the Remote Management policy. The password
set by the user takes precedence over the password configured by the administrator.
Rights: This option is available only when you select the managed device on which you
want to perform the remote operation. If an administrator has already assigned Remote
Management rights to you to perform the desired remote operation on the selected
managed device, you automatically gain access when the session initiates.
Port: Specify the port number on which the Remote Management Agent is listening. By
default, the port number is 5950.
Session Mode: Does not apply to the File Transfer operation.
or folder until you locate the device you want to
Workstations
novell-zenworks-
Device Management 59