Installing The Zenworks Adaptive Agent - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

3 Complete the wizard using information from the following table to fill in the fields.
Wizard Page
Select File to Import page
Configure Import
When you finish the wizard, the devices are added to the list in the Deployable Devices panel.

5.3 Installing the ZENworks Adaptive Agent

The following sections provide instructions for using the Web installation or a ZENworks Control
Center deployment task to install the ZENworks Adaptive Agent on a device.
Section 5.3.1, "Manual Installation," on page 82
Section 5.3.2, "Deploying the Agent to a Linux Device," on page 83
Section 5.3.3, "ZENworks Control Center Deployment Task," on page 84
Details
Browse for and select the CSV file that contains the devices you
want to import. At a minimum, the CSV file must contain the DNS
name or IP address for each device you want to import.
Map the columns in the CSV file to the device fields in the
ZENworks database. At a minimum, you must map the CSV file's
DNS name or IP address to the ZENworks database's DNS Name
field or IP Address field.
To create the information mappings:
1. Click Add to display the Specify Import Columns dialog box.
2. Fill in the following fields:
Field: Select the device field you want to map to a column in
the CSV file.
Column: Specify the number of the column to map to the
selected field.
3. Click OK to create the information mapping and add it to the
list.
4. To verify that the field is mapped to the correct column, click
Show Sample.
5. Repeat the above steps to create and verify additional
information mappings.
ZENworks Adaptive Agent Deployment 81