Deploying A Patch; Renewing A Patch Management License - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

2 In the Management Zone Settings panel, click Patch Management, then click Subscription
Service Information.
3 In the Start the Subscription Service list, select the ZENworks Server that you want to run the
subscription service, then click Start Service.
After the subscription service starts running, the Start Service button reads Service Running.
4 In the Subscription Communication Interval (Every Day at) list, select the time each day that
you want patches downloaded.
5 Click OK.

4.5.4 Deploying a Patch

To deploy a patch, you use the Deploy Remediation Wizard. The wizard lists only those devices to
which the patch applies and lets you deselect any devices that you don't want patched. In addition,
you can schedule when you want to deploy the patch.
The following steps assume that one or more patches are available from the subscription service.
1 In ZENworks Control Center, click the Patch Management tab.
2 In the Patches tab, select the patch you want to deploy by clicking the check box in front of the
patch, then click Actions > Deploy Remediation to launch the Deploy Remediation Wizard.
3 Follow the prompts to deploy the patch.
Click the Help button on each wizard page for detailed information about the page.

4.5.5 Renewing a Patch Management License

If your license to receive patches expires, you should renew it using the instructions in TID
3077372. See the
microsite.do).
62 ZENworks 10 Configuration Management Administration Quick Start
Novell Support Web site (http://www.novell.com/support/microsites/