Applying An Image - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

None: This option is displayed only for the Windows Image format and Ghost Image
format.
Optimize for Speed: Optimizes the compression to allow for the fastest reimaging time.
Use this option if CPU speed is an issue.
Optimize for Space: Optimizes the compression to minimize the image file's size to
conserve disk space. This can cause reimaging to take longer.
Balanced is the default option for the ZENworks Image format and Optimize for Speed is the
default option for the Windows Image format and Ghost Image format.
Create an Image Bundle: Leave this field deselected.
6 Review the information on the Image File Summary page, click Finished, then click OK.
Because imaging tasks are completed by Preboot Services, the image of the device is taken the
next time the device reboots. The Imaging Work panel, located on the device's Summary page,
shows that the work is scheduled. When the work is completed, the task is removed from this
panel.
7 To reboot the device immediately and initiate the imaging work, click Reboot/Shutdown
Workstation (or Reboot/Shutdown Server) in the left navigation panel.
The time required to take the image depends on the size of the device's drives.

4.3.3 Applying an Image

To apply an image to a device, you use the Create New Bundle Wizard to create an Imaging bundle.
The bundle contains the image you want to apply. In addition to helping you create the bundle, the
wizard also lets you assign it to devices. After creating the Imaging bundle, you then initiate the
imaging work.
"Creating the ZENworks Image Bundle" on page 48
"Creating the Third-Party Image Bundle" on page 50
"Initiating the Imaging Work" on page 52
Creating the ZENworks Image Bundle
To restore ZENworks images on a device, you must create the ZENworks Image bundle.
1 In ZENworks Control Center, click the Bundles tab.
48 ZENworks 10 Configuration Management Administration Quick Start