Modifying Configuration Settings At The Zone; Modifying Configuration Settings On A Folder - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

By default, your zone settings are preconfigured with values that provide common functionality.
You can, however, change the settings to best adapt them to the behavior you need in your
environment.
Section 3.5.1, "Modifying Configuration Settings at the Zone," on page 37
Section 3.5.2, "Modifying Configuration Settings on a Folder," on page 37
Section 3.5.3, "Modifying Configuration Settings on a Device," on page 38

3.5.1 Modifying Configuration Settings at the Zone

1 In ZENworks Control Center, click the Configuration tab.
2 In the Management Zone Settings panel, click the settings category (Content, Device
Management, Discovery and Deployment, Event and Messaging, and so forth) whose settings
you want to modify.
3 Click the setting to display its details page.
4 Modify the setting as desired.
For information about the setting, see
ZENworks 10 Configuration Management System Administration Reference
button in ZENworks Control Center.
5 When you have finished modifying the setting, click OK (or Apply) to save your changes.
If the configuration setting applies to devices, the setting is inherited by all devices in the zone
unless the setting is overridden at a folder level or a device level.

3.5.2 Modifying Configuration Settings on a Folder

1 In ZENworks Control Center, click the Devices tab.
2 In the Devices panel (on the Managed tab), browse for the folder whose settings you want to
modify.
3 When you've found the folder, click Details next to the folder name to display the folder's
details.
"Management Zone Configuration Settings" in the
or click the Help
Zone Configuration 37