Draft Packages - Novell ADMINSTUDIO 9.5 User Manual

Hide thumbs Also See for ADMINSTUDIO 9.5:

Table of Contents

Chapter 2: Using the Process Assistant

ConflictSolver Process Assistant

Draft Packages

When you import a package into the Application Catalog using the ConflictSolver Process Assistant, that package

is automatically imported into a special group called Draft, a temporary working group that isolates an imported

package that has not yet been checked for conflicts from the rest of the packages in the Application Catalog. The

Draft group is only visible when you select Current on the Select a Package Page of the Process Assistant.

Figure 2-2: Draft Group visible on the Select a Package Page

By placing these newly imported packages into the Draft group, you are indicating that these packages are in the

process of being prepared for distribution, and should not be used as target packages in conflict detection.

After you have performed validation, conflict detection, and conflict resolution on a Draft package, and it is ready

for distribution at your organization, you should then move it out of the Draft group using the Organize Package

Page of the Process Assistant. The package will then be visible on the Application Manager View.

While it is possible to move a package out of the Draft group before conflict detection and resolution have

been performed, it is not recommended.

ADS-0950-UG00

AdminStudio 9.5 User Guide