Removing An Uplink Card; Removing An Sfp - Cisco 10720 - Internet Router Installation And Configuration Manual

Removing and Installing an Uplink Card

Removing an Uplink Card

To remove the uplink card from the router, perform the following steps:
If the cable-management cover is installed on the router, it must be removed in order to access the power
Step 1
switch and uplink card. (See the
page
Power down the router. (See the
Step 2
Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
Step 3
"Preventing Electrostatic Discharge" section on page

Removing an SFP

The RPR/SRP uplink card uses SFP modules. If your uplink card does not use SFP modules, follow Step
1 and Step 2, and then go to Step 6.
Because invisible radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to radiation and do not stare into open apertures. Statement 125
Class 1 laser product. Statement 1008
Warning
Class 1 LED product. Statement 1027
Warning
Note You do not need to power down the router before you remove an SFP module. The router may remain
powered up during this procedure.
Cisco 10720 Internet Router Installation and Configuration Guide
5-50
5-68.)
Chapter 5
"Removing and Installing the Cable-Management System" section on
"Disconnecting Power from the Router" section on page
2-3.)
Maintaining the Cisco 10720 Internet Router
5-3.)
78-13062-10