Connecting Ports On The Uplink Cards - Cisco 10720 - Internet Router Installation And Configuration Manual

Chapter 3 Installing the Cisco 10720 Internet Router

Connecting Ports on the Uplink Cards

The fiber-optic connectors must be free of dust, oil, and other contaminants. Carefully clean the
Note
fiber-optic connectors using a fiber cleaning kit. See the Inspection and Cleaning Procedures for Fiber
Optic Connections document for specific information and instructions.
Figure 3-12 Simplex Optical Cable
Figure 3-13 Duplex Optical Cable
Attach either one duplex optical cable or two simplex optical cables between the card and the device to
which the card is connected. (See Figure 3-16.)

Connecting Ports on the Uplink Cards

Before connecting the ports on an uplink card, install the cable-management tray. For more information,
see the "Removing and Installing the Cable-Management System" section on page 5-68.
For cable and connection specifications, refer to the Cisco 10720 Internet Router Uplink Cards
Installation and Configuration publication.
Cisco 10720 Internet Router Installation and Configuration Guide
3-12
78-13062-10