Installing The Cable-Management System - Cisco 10720 - Internet Router Installation And Configuration Manual

Removing and Installing the Cable-Management System

Installing the Cable-Management System

Perform the following steps to install the cable-management system:
Power down your router. (See the
Step 1
Step 2 Attach an ESD-preventive wrist strap to your wrist, and to the router or to a bare metal surface. (See the
"Preventing Electrostatic Discharge" section on page
Figure 5-73
Step 3 Attach the cable-management tray to the router using four of the 3.5 mm x 6 mm screws that ship with
the router. Secure the tray with two screws on each side of the router chassis. (See
Step 4 Connect all interface cables to their respective ports if necessary.
Figure 5-74
Separate the cables and lead them out the sides of the cable-management system. Use a cable tie to keep
Step 5
the cables together. (See
Note
Cisco 10720 Internet Router Installation and Configuration Guide
5-70
Attaching the Cable-Management Tray
Managing Interface Cables with the Cable-Management Tray
Figure 5-74.)
To avoid damage to the cables, avoid excessive bending.
Chapter 5
"Disconnecting Power from the Router" section on page
2-3.)
RE SE T
CO NS
OL E AU
AC OK
X
DC OK
OT F
AC OK
DC OK
OT F
DO N NO
T RE MO
OR INS VE
ER T CA
WIT H TH BLE S
E PO WE
R ON
INP UT 10
0-2 00 - 50
RE SE T
CO NS
OL E AU AC OK
X
DC OK
OT F
AC OK
DC OK
OT F
DON NOT
REM OVE
OR INS
ERT CAB
WIT H THE LES
POW ER
ON
INP UT 100
-20 0- 50/
60H z 2-5
A
Maintaining the Cisco 10720 Internet Router
/60 Hz 2-5
A
Figure
5-3.)
5-73.)
78-13062-10