Additional Configuration Features; Saving The Configuration To Nvram; Using The Show Commands; Using The Show Running Configuration Command - Cisco 10720 - Internet Router Installation And Configuration Manual

Additional Configuration Features

Additional Configuration Features
The following sections provide information on additional router configuration and monitoring
procedures:
•
•
•
•
•
•
•
•
•
•
•
•

Saving the Configuration to NVRAM

To save your configuration to NVRAM, use the copy running-config startup-config command.
Router# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Router#

Using the show Commands

You can display router information using the show commands described in the following sections:
•
•
•

Using the show running configuration Command

Use the show running-configuration command to verify the router's configuration.
router# show running-configuration
Building configuration...
Current configuration : 3791 bytes
!
version 12.0
no service pad
service timestamps debug uptime
service timestamps log uptime
Cisco 10720 Internet Router Installation and Configuration Guide
3-42
Saving the Configuration to NVRAM, page 3-42
Using the show Commands, page 3-42
Monitoring Optical Power, page 3-45
Configuring Basic SRP Functionality, page 3-46
Configuring POS Functionality, page 3-46
Configuring Fast Ethernet, page 3-47
Configuring Gigabit Ethernet, page 3-47
Configuring TDR on TX Access Card, page 3-47
Assigning IP Information, page 3-47
Enabling Write Permission to Bootflash, page 3-47
Upgrading the Cisco IOS Software Image, page 3-47
Upgrading ROM Monitor, page 3-48
Using the show running configuration Command, page 3-42
Using the show version Command, page 3-44
Using the show environment all Command, page 3-45
Chapter 3 Installing the Cisco 10720 Internet Router
78-13062-10