Installing The Sfp Modules On The Access Card - Cisco 10720 - Internet Router Installation And Configuration Manual

Chapter 5 Maintaining the Cisco 10720 Internet Router

Installing the SFP Modules on the Access Card

Use the information in this section to install Gigabit Ethernet (GE) SFP modules in the access card.
Note
Note
Installing a Bale Clasp GE SFP Module
To install a bale clasp GE SFP module in the access card, perform the following steps:
Step 1 Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
"Preventing Electrostatic Discharge" section on page
Step 2 Hold the SFP module with the hardware label facing up, as illustrated in
Caution The SFP module must be inserted with the hardware label facing up to avoid damaging the SFP module
or access card.
Figure 5-68
1
Close the bale clasp on the SFP module by pushing the clasp in the upward direction before inserting the
Step 3
SFP module.
Caution Close the bale lever on the SFP module prior to inserting the SFP module into the port cage to ensure proper
engagement. The bale lever is considered closed when it is in the upright position. See
lever is left open during insertion, there is a possibility that the SFP module may become stuck in the port
78-13062-10
Use only SFP modules purchased from Cisco Systems.
The Cisco 10720 is a Class A product when using copper the SFP-GE-T= module in the Cisco 10720
GE-FE-TX-B= access card. The Cisco 10720 is a Class B product when using optical SFP modules
in the Cisco 10720 GE-FE-TX-B= access card.
Installing the Bale Clasp SFP Module in the Access Card
1 0 7 2 0 - G
E - F E - T
X
2
Access card
2-3.)
1
2
GE SFP module
Cisco 10720 Internet Router Installation and Configuration Guide
Removing and Installing an Access Card
Figure 5-1.
Figure 5-59. If the bale
5-65