Removing A Bale Clasp Sfp - Cisco 10720 - Internet Router Installation And Configuration Manual

Chapter 5 Maintaining the Cisco 10720 Internet Router
Because invisible radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to radiation and do not stare into open apertures. Statement 125
Class 1 laser product. Statement 1008
Warning
Warning Class 1 LED product. Statement 1027
The procedure for removing a small form-factor pluggable (SFP) module is described in the following
sections:
•
•
Note You do not need to power down the router before you remove an SFP module. The router may remain
powered up during this procedure.

Removing a Bale Clasp SFP

To remove a bale clasp SFP module from the access card, perform the following steps:
Step 1 Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
"Preventing Electrostatic Discharge" section on page
Step 2 Remove all optical interface cables from the SFP Gigabit Ethernet port. (See
Step 3 Open the bale clasp on the SFP module by pressing the clasp downward until it is in a horizontal position
as shown in
Step 4 Grasp the SFP module by the bale clasp and gently pull it out of the Gigabit Ethernet slot as shown in
Figure
78-13062-10
Removing a Bale Clasp SFP, page 5-51
Removing a Latch SFP, page 5-61
Figure 5-53.
5-53.
2-3.)
Cisco 10720 Internet Router Installation and Configuration Guide
Removing and Installing an Access Card
Figure 5-52.)
5-59