Cisco 10720 - Internet Router Installation And Configuration Manual page 191

Chapter 5 Maintaining the Cisco 10720 Internet Router
Figure 5-71
Verify that all cables are safely secured before detaching the cable-management cover. If the
Step 2
cable-management cover is not installed, go to Step 4.
Caution To avoid accidental damage to router cables or card ports, remove all cables before removing the
cable-management tray.
Step 3 Remove the cable-management cover from the router by removing the four screws that secure the cover
to the router. (See
Power down the router. (See the
Step 4
Step 5 Remove cable ties and separate the interface cables if needed to lead the cables into the inside of the
cable-management tray. (See
Remove all interface cables from their respective ports.
Step 6
Figure 5-72
Step 7 Detach the cable-management tray from the router by removing the two 3.5 mm x 6 mm screws on each
side of the router. (See
78-13062-10
Removing the Cable-Management Cover
C IS C O
1 0 7 2 0 IN
T E R N E
T R O U T
E R
Figure 5-72.)
"Disconnecting Power from the Router" section on page
Figure 5-75.)
Removing the Cable-Management Tray
Figure 5-72.)
Cisco 10720 Internet Router Installation and Configuration Guide
Removing and Installing the Cable-Management System
RE SE T
CO NS
OL E AU
AC OK
X
DC OK
OT F
AC OK
DC OK
OT F
DON NOT
REM OVE
OR INS
ERT CAB
WIT H THE LES
POW ER
ON
INP UT 100
-20 0- 50/
60H z 2-5
A
RE SE T
CO NS
OL E AU AC OK
X
DC OK
OT F
AC OK
DC OK
OT F
DO N NO
T RE MO
OR INS VE
ER T CA
WIT H TH BLE S
E PO WE
R ON
INP UT 10
0-2 00 - 50
/60 Hz 2-5
A
5-3.)
5-69