Cisco 10720 - Internet Router Installation And Configuration Manual page 188

Removing and Installing an Access Card
cage. To remove the SFP module, use a small flathead screwdriver to gently lift the cage tongue (located
underneath the SFP module) away from the SFP module body, thus disengaging the SFP module. The SFP
module is not damaged by this operation.
Step 4 Insert the SFP into the appropriate GE port and gently push on it until the SFP module snaps into the
slot. (See
Installing a Latch GE SFP Module
To install a latch GE SFP module in the access card, perform the following steps:
Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
Step 1
"Preventing Electrostatic Discharge" section on page
Figure 5-69
1
Step 2 Hold the SFP module with the hardware label facing up, as illustrated in
The SFP module must be inserted with the hardware label facing up to avoid damaging the SFP module
Caution
or the uplink card.
Insert the SFP into the appropriate RPR/SRP uplink card slot and gently push on it until the module snaps
Step 3
into the slot tightly. (See
Close the latch to lock the SFP module into the slot.
Step 4
Cisco 10720 Internet Router Installation and Configuration Guide
5-66
Figure 5-59.)
Installing the Latch SFP Module in the Access Card
1 0 7 2 0 - G
E - F E - T
X
2
Access card
Figure
Chapter 5
2-3.)
1
2 GE SFP module with latch
5-69.)
Maintaining the Cisco 10720 Internet Router
Figure 5-69.
78-13062-10