Setting Up The Router On A Desktop - Cisco 10720 - Internet Router Installation And Configuration Manual

Setting up the Cisco 10720 Internet Router
Figure 3-7
Step 5 Match the holes in the wall-mounting brackets to the predrilled holes on the mounting surface. Mount
the brackets to the wall using the 12 1-1/4-inch screws. (See

Setting up the Router on a Desktop

Use the four rubber feet included with the accessory kit to prepare the Cisco 10720 Internet Router for
desktop setup. To set up the router on a desktop, perform the following steps:
Step 1 Locate the rubber feet that came with the router.
Step 2 Attach an ESD-preventive wrist strap to your wrist, and to the router chassis or to a bare metal surface.
(See the
Step 3 Turn the router upside down to expose the bottom panel.
Cisco 10720 Internet Router Installation and Configuration Guide
3-8
Wall-Mount Rack
"Preventing Electrostatic Discharge" section on page 2-3
Chapter 3 Installing the Cisco 10720 Internet Router
Figure 3-7.)
for additional information.)
78-13062-10