Connecting Ethernet Ports On The Access Card; Installing A Bale Clasp Sfp; Installing A Latch Sfp - Cisco 10720 - Internet Router Installation And Configuration Manual

Connecting Ethernet Ports on the Access Card

Connecting Ethernet Ports on the Access Card
Install the cable-management tray before you connect the copper or optical fiber cable to a Fast Ethernet
port or to an SFP module on the Gigabit Ethernet port on the access card. For more information, see the
"Removing the Cable-Management System" section on page
For cable and connection specifications, refer to the
Installation and Configuration
the access card.
To connect the interface cables to the access card ports, perform the following:
Attach an ESD-preventive wrist strap to your wrist, and to the router or to a bare metal surface. See the
Step 1
"Preventing Electrostatic Discharge" section on page
Verify that the router is turned off and disconnected from its power source
Step 2
Installing a small form-factor pluggable Gigabit Ethernet (GE) (SFP) module in the access card GE port
is described in the following sections:
•
•
You do not need to power down the router before you install an SFP. The router may remain powered
Note
up during this procedure.
The Fast Ethernet ports are suitable for connection to intra-building wiring only, as per GR-1089,
Note
Issue 3.

Installing a Bale Clasp SFP

To install a bale clasp GE SFP module in the access card, perform the following steps:
Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
Step 1
"Preventing Electrostatic Discharge" section on page
Hold the SFP module with the hardware label facing up, as illustrated in
Step 2
Caution The SFP module must be inserted with the hardware label facing up to avoiding damaging the SFP
module or the access card.
Cisco 10720 Internet Router Installation and Configuration Guide
3-22
Installing a Bale Clasp SFP, page 3-22
Installing a Latch SFP, page 3-23
Cisco 10720 Internet Router Access Card
publication. See Figure 3-21
2-3.
2-3.)
Chapter 3 Installing the Cisco 10720 Internet Router
5-68.
for an example of a typical cable used for
Figure 19.
78-13062-10