Cleaning the Fiber-Optic Connections
See the
that identifies late collisions.
Carrier Signal
The lost carrier, no carrier numbers track the number of lost carrier detect signals that have occurred.
•
•
•
Cleaning the Fiber-Optic Connections
For information about cleaning fiber-optic cable connectors and receptacles, see the
Cleaning Procedures for Fiber-Optic Connections
procedures and equipment required to properly clean fiber-optic connections.
Cisco 10720 Internet Router Installation and Configuration Guide
4-22
"Verifying Interface Configuration" section on page 4-19
If the transmit clock signal is not active, check the interface for malfunction.
Check for a cable problem.
Carrier signal resets can occur when an interface is in one of the following states:
Looped back.
–
Shut down.
–
for a complete example of the output
document. It provides detailed illustrations and photos of
Chapter 4
Troubleshooting
Inspection and
78-13062-10