Removing A Latch Sfp - Cisco 10720 - Internet Router Installation And Configuration Manual

Chapter 5 Maintaining the Cisco 10720 Internet Router
Figure 62
1

Removing a Latch SFP

To remove a latch SFP module from the access card, perform the following steps:
Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
Step 1
"Preventing Electrostatic Discharge" section on page
Remove all optical interface cables from the SFP Gigabit Ethernet port. (See
Step 2
Push the small latch on the bottom front of the SFP to release the module from the connector in the
Step 3
Gigabit Ethernet slot.
Grasp the SFP module by the sides and gently pull it out of the Gigabit Ethernet slot.
Step 4
Protect your access card by inserting clean SFP cage covers into the SFP cage when there is no SFP
Step 5
installed, as shown in
78-13062-10
Installing an SFP Cage Cover
1 0 7 2 0 - G
E - F E - T
X
SFP cage cover
Chapter 5, "Maintaining the Cisco 10720 Internet Router," Figure
1
2-3.)
Cisco 10720 Internet Router Installation and Configuration Guide
Removing and Installing an Access Card
Figure 5-52.)
5-54.
5-61