Start Virtual Disk Initialization
This command starts the formatting of a virtual disk in a storage array.
NOTE:
Initializing a virtual disk is a long-running operation that you cannot stop.
Syntax
start virtualDisk [virtualDiskName] initialize
Parameter
Parameter
virtualDisk
Stop Configuration Database Diagnostic
This command stops the diagnostic test to validate the configuration
database in the controller firmware that was started by the start
storageArray configDbDiagnostic command.
Syntax
Stop storageArray configDbDiagnostic
Parameters
None.
NOTE:
The controller firmware returns a confirmation that the diagnostic test was
cancelled. In addition, the database configuration diagnostic test can be started
through the storage management software GUI but cannot be stopped through the
storage management software GUI. If you want to stop a running diagnostic test,
you must use the
command.
256
Script Commands
Description
Name of the virtual disk for which to start the formatting. You
must put brackets ([ ]) around the virtual disk name. If the
virtual disk name has special characters, you must also put
quotation marks (" ") around the virtual disk name.
stop storageArray configDbDiagnostic