Save Raid Controller Module Nvsram; Save Storage Array Configuration - Dell PowerVault MD3220 Cli Manual

Parameter
Parameter
logFile

Save RAID Controller Module NVSRAM

This command saves a copy of the RAID controller module NVSRAM values
to a file. This command saves all regions.
Syntax
save controller [(0 | 1)] NVSRAM file="filename"
Parameters
Parameter
controller
file

Save Storage Array Configuration

This command creates a script file that you can use to create the current
storage array virtual disk configuration.
Syntax
save storageArray configuration file="filename"
[(allConfig | globalSettings=(TRUE | FALSE)
virtualDiskConfigAndSettings=(TRUE | FALSE)
hostTopology=(TRUE | FALSE)
lunMappings=(TRUE | FALSE))]
182
Script Commands
Description
Name of the file to which to write the log sense data. You
must put quotation marks (" ") around the file name.
Description
RAID controller module with the NVSRAM values to save.
Valid RAID controller module identifiers are 0 or 1, where, 0
is the RAID controller module on the left and 1 is the RAID
controller module on the right when viewed from the rear of
the enclosure. You must put brackets ([ ]) around the RAID
controller module identifier.
Name of the file in which to save the values. You must put
quotation marks (" ") around the file name.