Dell PowerVault MD3220 Cli Manual page 169

Parameter
diskGroup
newDiskGroup
userLabel
virtualDiskWWID
capacity
offset
raidLevel
segmentSize
dssPreallocate
Description
The name of the disk group in which you want to
create the new virtual disk. (To determine the names of
the disk groups in your storage array, run the
storageArray profile
Name to give the new virtual disk. Enclose the new
virtual disk name in double quotation marks (" ").
The name of the virtual disk that you want to recover.
Enclose the virtual disk name in double quotation
marks (" ").
The world wide name of the virtual disk that you want
to recover. The name is a 16 byte identifier, for
example, 60080E500017B4320000000049887D77.
Enclose the identifier in double quotation marks ("").
Size of the virtual disk that you are adding to the
storage array. Size is defined in units of bytes.
NOTE:
A space must be added between the last digit and
the size (bytes, KB, MB, or GB) for values greater than 9.
If you do not specify a capacity, all the available physical
disk capacity in the disk group is used. If you do not
specify the capacity unit, bytes is used as the default
unit.
Number of blocks from the beginning of the disk group
to the beginning of the referenced virtual disk (1 block
is equal to 512 bytes).
RAID level of the disk group that contains the physical
disks. Valid values are 0, 1, 5, or 6.
Amount of data (in kilobytes) that the RAID controller
module writes on a single physical disk in a virtual disk
before writing data on the next physical disk. Valid
values are 8, 16, 32, 64, 128, 256, or 512. For
information about the segmentSize parameter, see
"Using the Auto Configure Command" on page 53.
The setting to turn on or turn off allocating virtual disk
storage capacity for future segment size changes. To
turn on allocation, set this parameter to TRUE. To
turn off allocation, set this parameter to FALSE.
command.)
Script Commands
show
169