Show Storage Array Auto Configure - Dell PowerVault MD3220 Cli Manual

Parameter
healthStatus
hostTypeTable
hotSpareCoverage
features
time
virtualDiskDistribution
summary
NOTE:
When you save the information to a file, you can use the information as a
record of your configuration and as an aid during recovery.

Show Storage Array Auto Configure

This command shows the default autoconfiguration that the storage array
creates if you issue the autoConfigure storageArray command. To determine
whether the storage array can support specific properties, enter the parameter
for the properties when you issue this command. You do not, however, need to
enter any parameters for this command to return configuration information.
If you do not specify any properties, this command returns the RAID 5
candidates for each physical disk type. If RAID 5 candidates are not available,
this command returns candidates for RAID 1 or RAID 0. In order to view the
RAID 6 autoConfiguration options, you must specify the raidLevel option.
When you specify auto-configuration properties, the RAID controller
modules validate that the firmware can support the properties.
Description
Displays the health, logical properties, and
physical component properties of the storage
array.
Displays a table of all host types known to the
RAID controller module. Each row in the table
displays a host type index and the platform the
index represents.
Displays information about which virtual disks of
the storage array have hot spare coverage and
which virtual disks do not.
Displays a list of the feature identifiers for all
enabled features in the storage array.
Displays the current time to which both RAID
controller modules in the storage array are set.
Displays the current RAID controller module
owner for each virtual disk in the storage array.
Returns a concise list of information about the
storage array configuration.
Script Commands
235