About The Script Commands - Dell PowerVault MD3220 Cli Manual

About the Script Commands

You can use the script commands to configure and manage a storage array.
The script commands are distinct from the command line interface (CLI)
commands; however, you enter the script commands using the command line
interface. You can enter individual script commands, or run a file of script
commands. When entering an individual script command, include it as part
of a CLI command. When running a file of script commands, include the file
name as part of a CLI command. The script commands are processed by a script
engine that performs the following functions:
• Verifies command syntax
• Interprets the commands
• Converts the commands to the appropriate protocol-compliant
commands, which is, in turn, run by the RAID controller module
• Passes the commands to the storage array
At the storage array, the redundant array of independent disks (RAID)
controller modules in the storage array runs the script commands.
The script engine and script commands support the storage array
configuration and management operations listed in Table 2-1.
Table 2-1. Configuration and Management Operations
Operation
Virtual disk, disk group
configuration
Physical disk configuration
RAID controller module
configuration
Activities
Creating, deleting, and setting priority; labeling;
setting physical disk composition when creating
virtual disks; setting segment size; and setting media
scan control
Configuring the hot spare
Defining virtual disk ownership, changing mode
settings, defining network settings, and setting host
port IDs
About the Script Commands
2
29