Virtual Disk Copy Commands
"Create Virtual Disk Copy" on page 149
"Recopy Virtual Disk Copy" on page 166
"Remove Virtual Disk Copy" on page 173
"Set Virtual Disk Copy" on page 223
"Show Virtual Disk Copy" on page 242
"Show Virtual Disk Copy Source Candidates" on page 243
"Show Virtual Disk Copy Target Candidates" on page 244
"Stop Virtual Disk Copy" on page 260
Commands Listed Alphabetically
Following are the script commands listed alphabetically.
Activate Storage Array Firmware
This command activates firmware previously downloaded to the pending
configuration area in the RAID controller modules in the storage array.
Syntax
activate storageArray firmware
Parameters
None
Autoconfigure Storage Array
This command automatically configures a storage array. Before entering the
autoConfigure storageArray command, run the show storageArray
autoConfiguration command. The show storageArray
autoConfiguration command returns configuration information in the form
of a list of valid physical disk types, RAID levels, virtual disk information, and
hot spare information. (This list corresponds to the parameters for the
autoConfigure storageArray command.)
Script Commands
115