Start Physical Disk Reconstruction; Start Secure Physical Disk Erase - Dell PowerVault MD3220 Cli Manual

Start Physical Disk Reconstruction

This command starts reconstructing a physical disk.
Syntax
start physicalDisk [enclosureID,slotID]
reconstruct
Parameters
Parameter
physicalDisk

Start Secure Physical Disk Erase

This command erases all of the data from one or more self encrypting disk
(SED) physical disks so that they can be reused as SED physical disks. Run
this command only when the SED physical disks are no longer part of a secure
disk group, or when the security key is unknown.
NOTE:
When performing a secure erase operation on all physical disks in an array
that contains only SED physical disk type, the physical disks should be erased in two
groups using the
For example, if there are seven (7) SED physical disks, the secure erase can be
performed by executing:
start secureErase physicalDisks [0,0 0,1 0,2 0,3];
start secureErase physicalDisks [0,4 0,5 0,6];
Syntax
start secureErase (physicalDisk
[enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2,
slotID2 ... enclosureIDn,slotIDn])
254
Script Commands
Description
Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.
start secureErase physicalDisks[]
command.