Reset Storage Array Iscsi Baseline - Dell PowerVault MD3220 Cli Manual

Parameters
Parameter
controller
NOTE:
If you do not specify a RAID controller module, the age is reset for the
storage array battery or both RAID controller module batteries. If you specify a
RAID controller module, then the age for only that RAID controller module battery is
reset.

Reset Storage Array iSCSI Baseline

This command resets the iSCSI baseline for the storage array to 0.
Syntax
reset storageArray iscsiStatsBaseline
Parameters
None.
NOTE:
This command resets the baseline to 0 for both RAID controller modules in
the storage array. The purpose of resetting both of the RAID controller module
baselines is to help ensure that the counts are synchronized between the RAID
controller modules. If one RAID controller module resets but the second RAID
controller module does not reset, the host is informed that the RAID controller
modules are out of synchronization. The host is informed by the time stamps that
are reported with the statistics.
Example
-c "reset storageArray iscsiStatsBaseline;"
178
Script Commands
Description
Specifies the RAID controller module that contains the battery
for which to reset the age. Valid RAID controller module
identifiers are 0 or 1, where, 0 is the RAID controller module on
the left, and 1 is the RAID controller module on the right when
viewed from the rear of the enclosure. Use the controller
parameter only for RAID controller modules with batteries.