Error Codes In Log File - Canon VB-C300 Administrator's Manual

Error Codes in Log File

Winsock Error Codes
Codes
An operation was attempted on something that
10038
is not a socket.
Only one usage of each socket address
10048 (protocol/network address/port) is normally
permitted.
A socket operation encountered a dead
10050
network.
A socket operation was attempted to an
10051
unreachable network.
An existing connection was forcibly closed by
10054
the remote host.
A connection attempt failed because the
connected party did not properly respond after
10060 a period of time, or established connection
failed because connected host has failed to
respond.
No connection could be made because the
10061
target machine actively refused it.
A socket operation failed because the
10064
destination host was down.
A socket operation was attempted to an
10065
unreachable host.
Error Messages Description
This may be recorded in Version 1.1, however,
there is no necessary action.
All resources for communication are being
used. This frequently occurs when a black
screen problem occurs in Viewer layout
sequences.
This occurs when the PC recognizes that the
network is not available because the closest
router or Hub to the PC is powered off.
Normally, this cannot be recognized, therefore
it is rare that this error is reported.
This occurs when another network device
recognizes that the network is not available
because the router or Hub is powered off.
Normally, this cannot be recognized, therefore
it is rare that this error is reported.
The connection is disconnected by the camera
server due to camera server restart or other
cause. This may occur when the camera
server is restarted using the restart button on
the configuration page on the software-side.
However, this rarely occurs.
A timeout occurred in the TCP connection with
the camera server (This occurs when the
camera server is down).
The camera server rejected the TCP
connection (This occurs when the port number
specification is incorrect or other cause).
This is recorded when the camera server is
down (Normally, 10060 occurs).
There are no routes to connect to the camera
server (This may also occur when there is a
failure in the network cable connected to the
PC or HUB).
Messages List
9-31