Canon VB-C300 Administrator's Manual page 265

The changes you are trying to save cannot
be sent to the storage server (<storage
server name>) and will be lost.
<Communication Error Messages -
Details>
Are you sure you want to delete storage
server '<storage server name>'?
Are you sure you want to delete location
Camera
'<location name>'?
Summary
Are you sure you want to delete zone
window
'<zone name>'?
Are you sure you want to delete camera
server '<camera server name>'?
Do you want to save your configuration
changes?
There has been an error saving the
configuration on the Master Storage Server.
The master storage server host name is
Connect to
invalid. Please specify a valid host name or
Master
IP address.
Storage
Server dialog,
The master storage server port is invalid.
Connection
Please specify a value between 1 and
Error dialog
65535.
Proceeding will delete any schedules
Edit Camera associated with the following : <camera
server name>.
Server dialog
Click Yes to proceed, No to reconsider.
Event Search
There are no events to display
dialog
The length of the extracted video may not
exceed 1 hour.
Could not save video because there was
Extract Video no data to record.
dialog
Failed to extract the video after
<hh>:<nn>:<ss> because two or more
MPEG-4 tracks are included in the selected
time period.
Folder Name You must enter a non blank name. Please
dialog check your settings and try again.
Messages Cause
An error occurred while saving the settings
in the Camera Summary window.
An attempt was made to delete a Storage
Server other than the Master Storage
Server.
An attempt was made to delete the
location.
An attempt was made to delete the zone.
An attempt was made to delete the camera
server.
An attempt was made to close the [Camera
Summary] window without saving the
changes.
An attempt was made to save the settings,
however, saving the Master Storage Server
settings failed.
An attempt was made to connect with an
invalid host name/IP address.
An attempt was made to connect with an
invalid port number.
[OK] was pressed in the [Edit Camera
Server] dialog when a change was made to
the camera registered in the camera server.
No events to be displayed in Event Search
were found.
An attempt was made to configure the time
using a value longer than 1 hour.
The recorded video at the specified time
cannot be read.
You attempted to use [Extract Video] to
save recorded video for a time range that
spans two or more MPEG-4 recording
schedules.
An attempt was made to add a layout
folder without entering the name.
Messages List
9-23