Canon VB-C300 Administrator's Manual page 264

Messages List
This camera server has already been set
up without recording. Please check your
settings and try again.
Connection to the camera server could not
Adding/Editing be established.
a Camera Please verify that the host name or IP
Server address, user name, and password are
correct.
<Communication Error Messages -
Details>
The storage server of this version does not
support the specified camera.
Add/Edit
Camera
Connection to the camera server has been
Server dialog,
lost.
Add/Edit
Recording
Schedule
dialog, Motion
Detection
Settings
Failed to connect a camera server.
dialog, Sensor
Event Settings
dialog
At least one day must be selected.
At least one type of recording must be
selected.
Add/Edit The recording frame rate must be between
Recording '<fps>' and '<fps>'.
Schedule
You cannot use digital zoom when
dialog
[Custom] is selected.
If Night Mode is set to [Auto], please
confirm that exposure is set to [Auto] in the
camera control panel.
9-22
Messages Cause
When a camera server configured as [Do
not record] is already added, an attempt
was made to add or edit a camera server
using the same hot name/IP address and
port number.
Could not connect to the camera server.
You attempted to register VB-C500VD,
VB-C500D, VB-C60 or VB-C300 with an
older version of the Storage Server.
An error relating to the camera server
connection occurred.
An unknown error relating to the camera
server connection occurred.
[OK] was pressed without specifying the
weekday.
[OK] was pressed without selecting the
recording mode check box.
[OK] button was pressed after entering an
invalid frame rate.
Attempted to close the Add (Edit) Schedule
Item with VB-C60 digital zoom specified
while [Custom] was still selected.
[Night Mode] was set to [Auto] while
exposure was not set to [Auto] in the
camera control panel.