Viewer Start-Up Option - Canon VB-C300 Administrator's Manual

Viewer Start-up Option

You can set the start-up option of the Viewer to omit the display of Start-up screen (
to enter a user name and password (
You can place a shortcut icon on the Desktop for your convenience by following the method described below.
For this setting, you cannot use the shortcut icon that was automatically created on the Desktop after installing
this software, which is used for starting the Viewer.
Note
Password can be referred through the Properties of the shortcut icon. You need to make sure that the
Password is secure.
1. Right-click on the icon for NVR_Viewer.exe located in the installation directory and select [Create Shortcut]
from the menu. The shortcut icon will be created. Move it to the Desktop.
The default destination directory is shown below.
<System Drive>:\Program Files\Canon\WebView\NVR
Tip
<System Drive> is a drive that contains a directory (folder) in which the Operating System files are stored.
For example, if the Operating System is installed on Drive C, your system drive is Drive C.
2. Right-click on the shortcut icon that was moved onto the Desktop and select [Properties] from the menu.
Example
"C:\Program Files\Canon\WebView\NVR\NVR_Viewer.exe" -h=192.168.100.1 -p=80 -u=admin -pw=NVR
Make sure to enter a space after "C:\Program Files\Canon\WebView\NVR\NVR_Viewer.exe".
P. 4-5, P. 5-7).
Specify [Target] as follows (using alphanumeric characters)
-h=<IP address of the Storage Server>
-p=<port number>
-u=<user name>
-pw=<password>
-u and -pw can be omitted. When omitted, the start-up screen will not be
displayed ( P. 4-3, P. 5-6). Instead, the login screen for entering a
username and password is displayed. When you use the Viewer alone, you
also need to specify "nohost" for -h.
This specification is mandatory (
It can be omitted. When omitted, 80 is specified
( P. 4-5).
Specify the user name (
Specify the password (
Start the Viewer
P. 4-3) and login screen
P. 4-5, P. 5-7).
P. 4-4).
P. 4-4).
5-11