Scpi - Set Characters Per Inch; Scpi Set Characters Per Inch - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
SCPI —
Set Characters Per Inch
Format
Parameter
number:
Function
File
276
SCPI number;
number of characters per inch
The SCPI command sets the number of characters per inch (even if the UNIT command
designates a non-inch unit).
When a proportionally-spaced font is used and the font mode (FTMD) is 0 to 3 or 8 to
11, SCPI 0 (zero) must be specified to obtain the innate spacing of each character. A non-
zero specification results in unnatural spacing of proportional fonts.
SCPI 0 does not change the width of the space character.
The character spacing can also be controlled by the SCS (set character spacing)
command.
!R! RES; SLM 1; STM 2; EXIT;
This line has 10 characters per inch.
!R! SCPI 8; EXIT;
This line has 8 characters per inch.
!R! SFNT 'Helvetica', 10; SCS .2; EXIT;
This proportional font
is printed with fixed
spacing.
!R! SCS 0; EXIT;
This is correct proportional spacing.
!R! PAGE; EXIT;