Res - Reset - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
RES —
RESet
Format
Parameter
Function
220
RES;
None
The RES command causes a page break and resets parameters as indicated below.
Some reset values can also be changed by the FRPO command. For these, the factory
reset value is given, followed by the FRPO parameters that can be used to change this
value in parenthesis.
In HP-7475A emulation, the RES command resets the printer environment in the same
manner as the KC-GL DF instruction. Refer to section HP 7550A Emulation [KC-GL]
(Mode 8) of the Technical Reference manual.
The RES command does not:
• delete permanent macros or permanent fonts from memory
• delete positions or fonts stored by the SCP and SCF commands
• reset font attributes set by the SFA command
• change any values in permanent memory (Refer to the FRPO INIT command page.)
Parameter
LaserJet (PCL)
Command recogni- R (P9)
tion character
Emulation mode 6 (P1)
Unit of measure- Inches
ment
a
Number of copies 1
per page
Cassette Cassette 1 (main cassette) (R4)
Paper tray Face-down (R0)
Paper size Cassette size (R2)
Top margin 1/2 inch (150 dots) 0 (A1/2)
Left margin Left logical
Right margin Right logical
Bottom margin 1/2 inch (150 dots) Max. size (A7/8)
Page orientation Portrait (Orienta-
tion of font C5/2/3)
Line spacing 6 lpi (U0/1)
Character spacing 10 cpi (Spacing of
font C5/2/3)
Value after reset
(Related FRPO parameter)
IBM/Epson
←
a ←
←
←
a
a ←
a ←
0 (A3/4)
Max. size (A5/6)
Portrait (Orienta-
tion of font C5/2/3)
←
10 cpi (U2/3)
Related PRE-
SCRIBE Com-
mands
Diablo
←
SCRC
←
SEM
←
UNIT
←
COPY
←
PSRC
←
STAK
←
SPSZ
←
STM
←
SLM
←
SRM, SPW
←
SBM, SPL,
SLPP
† SPO
Portrait (C1)
←
SLS, SLPI
←
SCS, SCPI