Kyocera DP-1800 Command Reference Manual page 301

height:
maximum height of the font
U/I:
U = upright
I = italic
weight:
degree of bolding, from -7 (light) to +7 (bold)
type-face:
0 = Line Printer
1 = Pica 2 = Elite
3 = Courier
4 = Swiss 721
5 = Dutch 801
6 = Gothic
7 = Script
8 = Pret. Elite
9 = Caslon
10 = Orator
font-type:
0 = 7-bit, 96 characters (character codes 32 to 127)
1 = 8-bit, 192 characters (character codes 32 to 127 and 160 to 255)
2 = 8-bit, 256 characters (All character codes. The printing system must be set to the HP
transparency mode. See Emulation of the Technical Reference manual.)
Function
The SFA command specifies the attributes of the current bitmap font. It can be used to
change the default attributes of the bitmap font and will be ignored when the current font
is a scalable font. The font retains its new attributes until they are changed by another
SFA command or power is switched off. Font attributes are not reset by the RES (reset)
command.
The SFA command has two types of parameters. The executable parameters adjust the
intrinsic character and line spacing of the font. The non-executable parameters do not
change the appearance of the font at all, but they affect the way in which the font is
selected by word-processing software in the HP LaserJet emulation.
Executable Parameters
The first three parameters are required in every SFA command. The hmi parameter sets
the character spacing of a fixed font or the word spacing of a proportional font. The vmi
parameter adjusts the line spacing. The vmi and hmi parameters both use the unit value
designated by the UNIT command.
The third parameter designates the font as fixed or proportional. Normally you should
specify F for a fixed font (example: font 1) and P for a proportional font (example:
font 2).
If the font mode (FTMD) value is 15, the assigned attributes take effect immediately. If
the font mode value is less than 15, some of the attributes, although assigned to the font,
SFA
291