Fix Font Matrix; Print Logo Inline - IBM SUREMARK TF6 User Manual

Fix font matrix

This command is not supported for Models TI1 and TI2.
EIA-232 Syntax:
where:
Default:
Purpose:
Remarks:

Print logo inline

This command is not supported for Models TI1 and TI2.
EIA-232 Syntax:
where:
Purpose:
Remarks:
146
SureMark Printers User's Guide
ESC : n or X'1B 3A n'
n The character width to which all proportional characters will be
adjusted. The range of valid values is 8 ≤ n ≤ 32. Use X'00' to
disable this command and print proportional characters normally.
n = 00
To fix the matrix of proportional fonts. This command will be used mostly to
align numbers and decimal points.
v This command is valid only on proportional user-defined fonts.
v If the character is larger than the width defined by this command, then
the right side of the character will be truncated.
v If the character is smaller than the width defined by this command, then
the character will be centered in the space.
GS J d n1 n2 data or X'1D 4A d n1 n2 data'
d Relative height of the character.
0 Single high
1 Double high
n1 MSB of the logo width.
n2 LSB of the logo width.
data The data to form the graphics image.
To print a small logo inline with characters.
v Thermal station only
v Rotate characters must be disabled
v n1 and n2 indicate the number of dots of the bit image in the horizontal
direction. The number of dots is calculated as n1×256+n2 (after first
converting n1 and n2 to decimal).
v The logo is 24 dot rows high. If printed in double-high mode, the logo will
be 48 rows high.
v The number of data bytes to form the image is figured by
{((n1×256+n2)−1)/8+1}×24.
Updated April 2, 2009