2-­-6-­-2. Menu > Event > Motion - Vitek VT-CN1680 Manual

CHRONO Series DVR
PTZ can be synced with Event using its preset function. If an event occurs, PTZ moves to the position where event and position are
pre set. The above menu shows, Sensor 1 is set to sync to cameras 2, 3, 4 and 5. If you click the PTZ section, PTZ preset (position)
can be set for cameras in the event of Sensor activation.
PTZ event related preset can only be synched with Sensor/Motion/Video Loss events. If multiple events occur to a camera at once, it
takes events in order of Sensor > Motion > Video Loss.
2-6-2. MENU > EVENT > Motion
In Motion, system provides Motion Detection function. Set Motion Detection using Sensitivity, View and Area options.
Sensitivity: Select motion sensitivity from Very Low to Very High.
View: Turn on or off the motion zones on the screen when motion is detected.
Area: Define the area for motion detection.
Press Setup under Area to define motion detection areas. The blocks indicate the defined areas for motion detection.
Select Block: Use arrow keys to move around a box. Select individual blocks to set motion zones. Use number keys to select and
unselect blocks. (When using a mouse, left click)
Clear Block: Unselect all blocks inside a box
Select All: Select blocks on entire screen
Clear All: Unselect blocks on entire screen
In Record, each camera can be synchronized with a single or multiple motion
detections from other cameras. Press
motion detections.
30
to select cameras to be synchronized with