Motion Sensor; Motion Area Setup - Vitek VT-SRE Spire Elite User Manual

System Setting
\ \

Motion Sensor

Set the motion sensor of the camera .
1.
From <MEnU> -<SySTEM SETUP> - <CAMERA>,
select <MOTiOn SEnSOR>.
2.
Use the [▲▼◀▶/EnTER] buttons on the remote control
or use the mouse to specify the use of each option
item.
i ACTiVATiOn : turn on or off the motion sensor.
i MARK : Set to <On> to display the motion detection
indicator on each video tile.
i SEnSiTiViTy : Set the sensitivity level of the motion
sensor to either Daytime or nighttime.
i EDiT AREA : Specify the motion detection area.
3.
To apply the change, click <APPLy> in the bottom of the screen.
4.
When done, press the [ExiT] button on the remote control or click <CLOSE> in the lower screen. The confirmation
message appears and you will return to the previous menu.
•
The motion detection sensitivity may differ depending on the characteristics of the connected camera or the installation environment.

Motion Area Setup

From the motion sensor window, click <EDiT AREA> to display the area setup screen.
1.
Click <EDiT AREA> to move to the motion area setup screen.
2.
if using the remote control, press the [EnTER] button
to initiate the process.
3.
Use the arrow buttons to move to a desired block and
press [EnTER]. The area setup will begin.
Then, use the arrow buttons to specify the area. Press
[EnTER] to select/deselect the area.
Alternatively, when using a mouse you can use the drag-

and-drop method to specify or release the area.
4.
if you select the specified area again, it will be
released.
62
Red Block = Selected area. The screenshot above shows the entire

screen selected. These blocks are what triggers the motion sensor.