Turning On The System; Bar - Vitek VT-CN1680 Manual

CHRONO Series DVR

1-2. Turning on the System

Connecting the power cord will turn on the DVR. It will take approximately 10 to 30 seconds for the system to be initialized. Once
the system is initialized, it will display a live screen, and begin to record video automatically.
Note : To turn off the system, select SHUTDOWN under main menu (MENU > SHUTDOWN) and
unplug the power cord when the shutdown message appears.
Note : The HDD should be formatted before installing it for the first time.
"MENU > RECORD > Storage > HDD format"
1-3. Menu Bar
The menu bar will appear on the bottom of the screen as shown below.
- Display menu to load PTZ presets under PTZ mode.
PTZ Button Changes to the PTZ control mode from the live mode.
ZOOM Button Zooms the current image on the screen.
PIP Button Changes to PIP screen mode from live screen.
FREEZE Button Freeze the current screen.
AUDIO Button Selects a camera for live & playback audio output.
SPOT Button Assigns the SPOT output channel.
OSD Button Turns on/off the OSD display.
LOG Button Checks the system's log information.
ID Button Selects the DVR system ID. (Remote controller only)
Pressing the E.REC button stars Emergency Recording
E.REC Button
Mode of all camera channels, and displays "!" on the
screen. Pressing the button again will stop E.REC mode.
Status LED Power, HDD, Network, Alarm
Pressing the Menu will bring up the main menu list.
Shows the % of HDD being used.
Turns on when the HDD is set to be overwritten.
Sequence display mode.
Turns on when the system is connected to the network.
Turns on when the Alarm is being activated.
Mirroring mode.
13