Table of Contents
Advertisement
Value
0
300—57333
Value
V92
V90
V34
V32bis
V32
V22bis
V22
V23C, Bell212A
V.21, Bell103
Command
+MS=<carrier>,<automode>,
<min_rate>,<max_rate>
+MS?
+MS=?
+MSC=<src_v34>—Seamless Rate Change Enable
Table 3-108: Valid <max_rate> Range
Determined by modulation selected in <carrier> (default).
Value limited by modulation selected in <carrier>.
Table 3-109: Valid <max_rate> for each <carrier>
28000 bits/s—57333 bits/s in steps of 1333 bits/s.
28000 bits/s—57333 bits/s in steps of 1333 bits/s.
2400 bits/s—33600 bits/s in steps of 2400 bits/s.
4800 bits/s—19200 bits/s in steps of 2400 bits/s.
4800 bits/s—14400 bits/s in steps of 2400 bits/s.
2400 bits/s.
2200 bits/s.
1200 bits/s.
300 bits/s.
Table 3-110: +MS Extended Syntax Commands
Select or deselect transmission of the rate report result code.
Display the current status of the rate report result code.
Display the supported parameter values for DTE-DCE local
rate reporting.
Once a modulation is selected by the +MS command, the autorate in both
directions and the automode will be activated unless <max_rate> is specified by
the same command.
The settings of this command overwrite the settings of S28, S37, S38, S109.
Likewise, changes to these registers overwrite the settings of the +MS command.
Use this command to enable or disable V.34 seamless rate changes. Result
codes:
OK if <src_v34> = 0, 1.
ERROR if <src_v34> does not equal 0, 1.
Meaning
Meaning
Description
56K Softmodem
Command Reference
- 57
Advertisement
Table of Contents
