A8T=<Sig; Dr<Value>-Data Compression Reporting - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

Value
0
1
+A8T=<sig-
nal>,<1st_message>,<2nd_message>,<sig_en>,<msg_en>,<supp_delay
>—Send V.8 bis
Command
+A8T=<signal>,<1st_message>,
<2nd_message>,<sig_en>,<msg_en>,<supp_delay>
+A8T?
+A8T=?
+DR<value>—Data Compression Reporting
Result codes:
Command
+DR=0
+DR=1
Table 3-57: Valid <supp_delay> Values
No delay inserted (default).
Inserts a 1.5 s delay between transmitted V.8 bis signal and the
subsequent V.8 bis message.
+A8T Extended Syntax Commands
Table 3-58:
Use this command to enable or disable the compression report. If the
compression report is enabled, the +DR:<type> intermediate result code reports
the current DCE-DCE data compression type. It is issued after the error control
report (+ER) and before the final result code (e.g., CONNECT).
OK if <value> = 0, 1.
ERROR if <value> does not equal 0, 1.
Table 3-59: +DR Data Compression Report Value
This command disables the compression report.
This command enables the compression report.
Meaning
Description
Sends a V.8 bis command or message.
Displays the current configuration for sending a V.8
bis message or command.
Displays the supported configuration parameters.
Function
56K Softmodem
Command Reference
- 36