Table of Contents
Advertisement
+FMM, +FMM?
+FMR?—Version/Revision Information
+FMR, +FMR?
+FPR=<value>—Select FAX Port Rate
Result codes:
DTE Command*
+FPR=0
+FPR=1
+FPR=2
+FPR=4
+FPR=8
+FPR=10
+FPR=18
Table 4-4: +FMM Extended Syntax
Command
Displays the modem product identification.
This command returns the modem version code. Result codes:
This command always yields an OK result code.
•
Table 4-5: +FMR Extended Syntax
Command
This command sets the DTE to DCE FAX port rate. The +FPR command is
supported to ensure compatibility with communications software that issues the
this command.The 56K Softmodem does not maintain the traditional relationship
between the DTE and DCE that this command was designed to control. The 56K
Softmodem interfaces with the host system via a PCI or AC97 interface.
This command always yields and OK result code.
•
Table 4-6: +FPR Commands
Select automatic rate detection.
Set DTE-DCE to 2400 bits/s.
Set DTE-DCE to 4800 bits/s.
Set DTE-DCE to 9600 bits/s.
Set DTE-DCE to 19200 bits/s.
Set DTE-DCE to 38400 bits/s.
Set DTE-DCE to 57600 bits/s.
* The listed values do not have any significance for the 56K Softmodem. The
values listed here are only useful in controller based systems.
Description
Description
Displays the modem product identification.
Description
56K Softmodem
Command Reference
- 63
Advertisement
Table of Contents
