Frh=<Mod>-Receive Hdlc Data With <Mod> Carrier - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

DTE Command
+FPR=<value>
+FPR?
+FRH=<mod>—Receive HDLC Data with <mod> Carrier
Result codes:
Table 4-7: +FPR Extended Syntax
Does not perform any particular action in soft modem based systems.
Does not perform any particular action in soft modem based systems.
Use the +FRH command to instruct the modem to receive data framed in the
HDLC protocol at the modulation defined by Table 4-8: +FRH Commands on page
65.
CONNECT if <mod> = 3, 24, 48, 72—74, 96—98, 121, 122, 145, 146 and the
connection is established. This is an intermediate result code.
OK if <mod> = 3, 24, 48, 72—74, 96—98, 121, 122, 145, 146 and the connection
is established. This is a final result code.
ERROR if <mod> does not equal 3, 24, 48, 72—74, 96—98, 121, 122, 145, 146 or
the connection is not established. This is a final result code.
56K Softmodem
Command Reference
Description
- 64