Etbm=<Pending_Td>,<Pending_Rd>,<Timer>-Call Termination Buffer Management - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

Command
0
1
Command
+ESR=<value>
+ESR?
+ESR=?
Note:* Refer to ITU- T recommendation V.42 for a complete definition of the selective reject mode.
+ETBM=<pending_TD>,<pending_RD>,<timer>—Call Termination Buffer Manage-
ment
Result codes:
Table 3-79: +ESR Parameter Values
Enables the selective reject mode.
Disables the selective reject mode.
Table 3-80: +ESR Extended Syntax Commands
Turns on or turns off the selective reject mode.
Displays the current settings for the selective reject mode.
Displays the supported settings for the selective reject mode.
Use this command to set the behavior of the modem during call termination. The
<pending_TD> parameter controls how previously transmitted data remaining in
the DCE buffers is handled when the DTE request a disconnect from the call. The
<pending_RD> parameter controls how previously received data remaining in the
DCE buffers is handled when the remote DCE disconnects the call. The <timer>
parameter sets the maximum amount of time the 56K Softmodem will attempt to
deliver the buffered data before abandoning the attempt and discarding any
remaining data.
OK if <pending_TD> = 0—2 and <pending RD> = 0—2 and <timer> = 0—254.
ERROR if <pending_TD> does not equal 0—2 or <pending RD> does not equal
0—2 or <timer> does not equal 0—254.
Command Reference
Description
Description
56K Softmodem
- 45