Command
+ER=0
+ER=1
Table 3-75: +ER Error Control Reporting Intermediate Result Codes
Result Code
+ER: NONE
+ER: LAPM
+ER: ALT
Command
+ER=<value>
+ER?
+ER=?
+ES=<orig_rqst>,<orig_fbk>,<ans_fbk>—Error Control Selection
Result codes:
Table 3-74: +ER Control Reporting Commands
This command enables error control report (default).
This command disables error control report.
Data compression not in use.
V.42 LAPM protocol is in use.
V.42 alternative protocol is in use.
Table 3-76: +ER Extended Syntax Commands
Enables or disables error control reporting.
Displays the current setting for error control reporting.
Displays the supported error control reporting settings (0, 1).
Use this command to select the error correction mode. If the modem is operated
in V.80 mode (synchronous buffered mode), and +ES=,,8, the +ES? will always
return +ES: 6,,8. The setting of this command overwrites the \N command.
However, the +ES command is overwritten by the setting on a \N command.
OK if one of the combinations shown in Table 3-77: +ES Combinations.
ERROR all other parameter combinations.
Function
Description
Description
56K Softmodem
Command Reference
- 43