Vcid=<Value>-Caller Id - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

Value
+PMHT=<value>
+PMHT?
+PMHT=?
+VCID=<value>—Caller ID
Command
+VCID=0
+VCID=1
+VCID=2
Value
+VCID=<value>
+VCID?
+VCID=?
Table 3-120: +PMHT Extended Syntax Commands
Configure the 56K Softmodem response to a modem on hold request.
Display the current modem on hold settings.
Display the valid +PMHT parameter values.
Use this command to enable or disable caller ID. Result codes:
OK if <value> = 0—2.
ERROR if <value> = 0—2.
Table 3-121: Valid +VCID Commands
Disable caller ID.
Enable caller ID with formatted presentation.
Enable caller ID without formatting.
Table 3-122: +VCID Extended Syntax Commands
Configure caller ID.
Display current caller ID settings.
Display all valid +VCID parameter values.
Meaning
Meaning
Meaning
56K Softmodem
Command Reference
- 62