T<Time Delay>-Inactivity Timer; V<Value>-Protocol Result Code; B-View Numbers In Blacklist - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

Command
\R0
\T<time delay>—Inactivity Timer
Result codes:
Command
\T0
\T1—\T255
\V<value>—Protocol Result Code
Command
\V0
\V1
\V2
%B—View Numbers in Blacklist
Table 3-41: \R<value> Commands
Ring indicator is off after the telephone call is answered.
Use this command to specify the delay time used by the inactivity timer. The delay
time is the length of time in minutes that the modem waits during periods of
inactivity before disconnecting. Periods of inactivity are defined by no data being
sent or received by the DCE. To disable the inactivity timer, use the T0 command.
The delay time may also be specified in register S30 (see "S30—Inactivity Timer"
on page 89).
This function is only applicable in buffer mode.
OK if <time delay> = 0—255.
ERROR if <time delay> does not equal 0—255.
Table 3-42: \T<value> Commands
Inactivity timer disabled (default).
Specifies the length of time in minutes that the modem will wait
before disconnecting when no data is sent or received.
Use this command to enable or disable protocol result codes. Result codes:
OK if <value> = 0—2.
ERROR if <value> does not equal 0—2.
Table 3-43: \V<value> Commands
Disables protocol result code appended to DCE speed.
Enables protocol result code appended to DCE speed (default).
Enables protocol result code appended to DCE speed (same as \V1).
If blacklisting is in effect, this command displays the numbers that are currently
Functions
Function
Function
56K Softmodem
Command Reference
- 30