Setting Dte Rate To 230 Kbps - US Robotics Courier V.Everything Getting Started Manual

Setting DTE Rate to 230 Kbps

The DTE rate of your Courier V.Everything has been increased to 230
kbps to enhance throughput.
Note: This command is only supported on internal Courier V.Everything
modems with Plug and Play on external modems attached to high speed
serial cards.
You can only change the DTE rate on Courier V.Everything modems that
have a 25 MHz clock frequency. Earlier versions of the Courier had a 20
MHz clock frequency and do not allow 230 kbps DTE rate.
Use the following table to control the 230 kbps DTE rate:
To set the modem to operate
At Normal mode (115 kbps)
At Times Two mode (230 kbps)
Note: Using this command, if the DTE rate is set to 115 kbps the modem
will respond at 230 kbps. This command will take affect immediately
upon execution. The next AT command will operate at 230 kbps.
Using x2
Use this command
%G0
%G1
10-9