W<Value>-Store Current Configuration; Y<Value>-Select Stored Profile For Hard Reset; Z<Storage Location>=<Dialing Sting>-Store Telephone Number - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

&W<value>—Store Current Configuration
Result codes:
Command
&W0
&W1
&Y<value>—Select Stored Profile for Hard Reset
Result codes:
&Z<storage location>=<dialing sting>—Store Telephone Number
B1 L2 M1 E1 N1 Q0 V1 W2 X1 Y0 &C1 &D2 &G0 &J0 &K3 &L0 &Q5 &S0 %C3 %E2
\J0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:003 S07:060 S08:002
S09:050 S10:014 S11:095 S12:050 S14:138 S18:000 S20:000 S21:048 S22:022
S23:008 S27:073 S28:160 S29:050 S30:000 S31:010 S32:010 S33:000 S35:000
S36:007 S37:000 S38:002 S39:003 S40:040 S41:107 S42:001 S43:001 S48:007
S49:027 S50:015 S51:095 S52:007 S53:047 S54:002 S55:035 S56:000 S57:000
S58:030 S60:255 S61:000 S62:000 S63:030 S70:000 S83:005 S90:000 S91:010
S92:010 S93:006 S94:000 S95:129
TELEPHONE NUMBERS:
0 = 5557107
1 = 5557106
2 =
3 =
OK
Use this command to store the modems command options and all S registers
except S3, S4, and S5. The Z<value> command or a powerup reset, of the
modem, restores this profiles.
OK if <value> = 0, 1.
ERROR if <value> does not equal 0, 1.
Table 3-32: &W<value> Commands
Stores the current configuration as profile 0.
Stores the current configuration as profile 1.
This command does not change the behavior of the modem but is included for
compatibility with applications that issue the &Y command.
OK if <value> = 0, 1.
ERROR if <value> does not equal 0, 1.
Use this command to store a dialing string. The 56K Softmodem can save four
Function
56K Softmodem
Command Reference
- 25