S7-Wait Time For Carrier; S8-Pause Time For Dial Delay Modifier; S11-Dtmf Tone Duration; S12-Escape Guard Time - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

S7—Wait Time for Carrier
S8—Pause Time for Dial Delay Modifier
S11—DTMF Tone Duration
S12—Escape Guard Time
Base Unit: 1 s.
S7 sets the length of time (in seconds) that the modem will wait for a carrier before
hanging up. The timer starts when the 56K Softmodem finishes dialing (originate)
or two seconds after going off-hook (answer). In originate mode, the timer is reset
upon detection of an answer tone if allowed by country restrictions. The timer also
specifies the wait for silence time for the @ dial modifier in seconds. S7 is not
associated with the W dial modifier.
Range: 1—255.
Default: 50.
Unit: 1 s.
S8 sets the time, in seconds, that the 56K Softmodem will pause when a dial
delay modifier(,) is encountered in the dial string.
Range: 0—255.
Default: 2.
Base Unit: 1 s.
This register determines the dialing speed which is prefixed for each country. For
countries where change of the DTMF is not allowed, the value of S11 is set to 0.
The value in S11 has no effect on pulse dialing.
Range: 50—255.
Default: 95.
Base Unit: 1 ms.
This register sets the value in 0.02 s increments for the required pause after the
escape sequence.
Range: 0—255.
Default: 50.
Base Unit: 0.02 s.
56K Softmodem
Command Reference
- 88