Table of Contents
Advertisement
+GCAP Responses*
+FCLASS
+MS
+ES
+DS
Note:* ITU-T recommendation V.250 (05/99) identifies an additional response (+MV18S) that is not
included with the 56K Softmodem. +MV18S is for V.18 modulation control. For more information refer
to ITU-T recommendation V.250 (05/99).
+GCI=<T.35_country_code>—Country of Installation
Result codes:
Command
+GCI=<T.35_country_code>
+GCI?
+GCI=?
+GMI—Manufacturer Identification
Result codes:
Table 3-88: +GCAP Responses
DCE Control Standard
T.class 1, +F
+M commands
+E commands
+D commands
Use this command to set the modem country code. ITU-T Recommendation T.35
defines the country codes and the country names. Table 158 on page 82 has a
complete list of the T.35 country codes.
OK if <T.35_country_code> = valid country code as defined by Table 158.
ERROR if <T.35_country_code> does not equal valid country code as defined by
Table 158.
Table 3-89: +GCI Extended Syntax Commands
Set the country code.
Display the current country code setting.
Display all supported country code settings.
+GMI is an extended syntax command. It returns the modem manufacturer
and either the OK or ERROR result code. The +GMI=? syntax returns an
ERROR result code. The other two forms return an OK result code.
OK when using the +GMI or +GMI? syntax.
ERROR when using the +GMI=? syntax.
56K Softmodem
Command Reference
Description
Class 1 FAX DCE control
Modulation control: • +MS • +MR
Error control: • +ES • +EB • +ER •
+EFCS • +ETBM
Data compression • +DS • +DR
Description
- 48
Advertisement
Table of Contents
